explosion temperature
英 [ɪkˈspləʊʒn ˈtemprətʃə(r)]
美 [ɪkˈsploʊʒn ˈtemprətʃər]
网络 爆温
双语例句
- The Probability Analysis of Converter off Gas Explosion in the Middle Temperature Zone
转炉煤气中温段爆炸可能性的计算与分析 - In order to study the explosion temperature effect of KCl in permissible emulsion explosive for coal-mine, the theoretical calculation is carried out by using explosive detonation theory.
为研究氯化钾对煤矿许用乳化炸药爆温的影响，依据炸药爆轰理论进行了计算。 - Influence of pH on the critical explosion temperature of ammonium nitrate solution
pH值对硝酸铵水溶液临界爆炸温度的影响 - Electrical Explosion Temperature of Metal Thin Film Bridge Measured by Spectrum Radiation Method
光谱辐射测量金属薄膜桥电爆炸温度 - The result shows that the relationship between heat of explosion, explosion temperature and contents of KCI is linear.
结果表明，该炸药的爆热和爆温与氯化钾含量在适用范围内呈线性关系。 - The cause of the first explosion is that the temperature in the dryer rises, so the formaldehyde decomposes and releases heat which produces flammable gas.
分析了第一次爆炸是由于烘干箱内温度、压力升高，使甲醛分解、放热，产生可燃气体，压力升高，引起爆炸。 - Analysis on Tube Explosion in Low-temperature Section of High Temperature Superheater
高温过热器冷段爆管分析 - Deals with the form, size, gas/ liquid ratio, explosion and homogenization temperature, and salinity of the inclusions of minerals in main type antimony deposits in China.
讨论了中国主要类型锑矿床矿物包裹体形态、大小、气液比值、包裹体爆裂温度、均一化温度和盐度。 - Thermal explosion and times-to-ignition in uniform-temperature systems
均一温度系统的热爆炸和起爆延滞期 - This paper put forward two new terms: "critical explosion temperature" and "flame and explosion suppression agents". Through theoretical study and experiments, it was found that ZrO_2 could be used as an effective component in anti-explosion agents.
本文提出两个新概念：临爆点和燃爆消减剂，并根据理论与实验研究，遴选出燃爆消减剂的有效成分&ZrO2。 - A numerical method for computing the critical temperature ( T b) of thermal explosion of energetic materials from a set of data of thermal explosion temperature ( T I) and determined explosion induction ( t I) is presented.
提出了由一组热爆炸温度和实测爆炸延滞期数据计算含能材料热爆炸临界温度（Tb）的一种数值方法。 - Based on theory of the thermal explosion, prediction model of critical temperature, when dynamite transits from thermal decomposition to thermal explosion under nonisothermal conditions, has been derivated.
根据热爆炸理论，推导出了非等温条件下，炸药由热分解过渡到热爆炸时临界温度的预测模型。 - Anticorrosion Performance of Electro-Thermal Explosion Spraying Coatings at High Temperature
两种电热爆炸喷涂层高温防腐性能对比研究 - The effects of the relative density of mixture, the content of Al particle, the size of Al particle, the heating rate, the content of dilution Fe on the thermal explosion point temperature and the thermal explosion delay time are analyzed.
对工艺参数如混合物的相对密度、Al粉的相对含量、Al粉粒度、加热速率、Fe的相对含量对热爆点温度和热爆延滞时间的影响做了分析。 - Based on the energy conversation equation of chemical engineering thermodynamics, two computation methods of explosion temperature and pressure of gas explosion in vessels were built.
根据化工热力学能量守恒方程，推导出了两种容器内可燃气体爆炸温度和压力的计算方法。 - The temperature T_0 is called critical explosion temperature, at which the condensed phase and its vapor come to a balanced state, and the concentration of the combustible vapor comes to LEL.
临爆点是可燃物凝聚相与其蒸汽处于平衡状态时，可燃物的饱和蒸汽压为LEL值时的温度（T0）。 - Once the temperature of the environment exceeds the critical explosion temperature, the delayed-action time will shorten along with the temperature of the environment ascending;
一旦环境温度超过临界爆炸温度，随环境温度的升高，爆炸延滞期将变短； - Pulsed laser deposition of explosion boron nitride at ambient temperature
室温下用脉冲激光沉积E-BN薄膜 - Determination of Explosion Flame Temperature of Methane-Coal Dust
瓦斯煤尘爆炸火焰温度的测定 - Study on the Process of Thermal Explosion Self propagating High temperature Synthesis of Bulk Cermet
热爆SHS法制备金属陶瓷块体工艺过程研究 - Accident analysis and treatment of air pipe explosion at low temperature
空气管道低温态爆破的事故分析与处理 - The tube explosion occurring in a low temperature stage superheater of a gas fired industrial boiler was analyzed from various aspects, such as boiler design, superheater structure and layout, etc. With the cause of explosion being identified some effective measures were proposed to solve the problem.
针对一台燃气工业锅炉出现的低温级过热器爆管问题，从设计、过热器结构、布置等诸方面分析了引起爆管的原因，并提出了解决爆管的措施。 - In the field of physics test of explosion, it is often been adopted to measure the parameters of explosion real-time, such as explosion speed, explosion effect time and explosion temperature and so on.
爆轰物理实验中，通常需要实时测量爆炸过程的速度、作用时间、温度以及压力等参数。 - The certain heating rate and aluminium content are needed if the thermal explosion occurs at low temperature in Ti-C-Al system.
升温速度及Al含量只有超过一定值时，该体系才能在较低温度发生热爆反应； - Using the single chamber dual thrust rocket engine explosion of gas flow temperature field simulation environment, the storage unit to verify the test experiments, the test unit can store a complete record of temperature data.
最后，利用单室双推力火箭发动机燃气流场模拟爆炸温度场环境，对存储测试单元性能进行了验证实验。实验结果表明，存储测试单元能够完整的记录温度变化的数据。 - A detailed description on the development of explosion flame temperature system of hardware and software was given. The hardware circuit mainly includes I/ V conversion circuit, three-stage amplifier, sample and hold circuit, A/ D convert circuit and external expanding memory.
论文详细阐述了该爆炸火焰测温系统的硬件和软件设计，硬件电路主要包括I/V转换电路，三级放大电路，采样保持电路，以及A/D转换电路和外扩存储电路。 - In recent years, fire frequently happened in buildings which always leads to collapse and gas explosion causing high temperature and dynamic impact loading on structure at the same time.
近年来，建筑火灾事故频发，并常引起倒塌事故和煤气爆炸事故，对建筑结构同时造成高温和动态冲击荷载作用。